Engineering and architectural drawing scales The recommended scales for use in engineering drawing practice and in architectural and building drawings are specified in Table 5.1.
NOTE: If, for special applications, there is need for a larger enlargement scale or a smaller reduction scale than those shown in the table, the recommended range of scales may be extended in either direction, provided that the required scale is derived from a recommended scale by multiplying by integral powers of 10. In exceptional cases where for functional reasons the recommended scales cannot be applied, intermediate scales may be chosen.
Australian Standard
Technical drawing
Part 101: General principles
For history before 1992, see Preface.
Second edition AS 1100.101—1992.
PUBLISHED BY STANDARDS AUSTRALIA
(STANDARDS ASSOCIATION OF AUSTRALIA)
1 THE CRESCENT, HOMEBUSH, NSW 2140
ISBN 0 7262 7806 8
Accessed by WOODSIDE ENERGY LTD on 21 Nov 2001
product engineering solutions | Most valuable blog
ReplyDeleteI think this is an informative post and it is very useful and knowledgeable. therefore, I would like to thank you for the efforts you have made in writing this article. medical device design company
ReplyDelete