VIDEO 3D BOOTH UNIK
Popular Posts
-
The generic product development process consists of six phases, as illustrated in Exhibit 2-2. The process begins with a planning phase, whi... -
Is a simple machine where Ram Horizontal movement (movement back and forth). Ingestion of this machine only move in one direction only... -
The other standard orthographic projection method is first angle projection. The only difference between first angle and third angle ... -
Begins this process by measuring the amount of thermosetting plastic resin required to be placed in the mold cavity. Then the mold is ... -
From the perspective of the investors in a for-profit enterprise, successful product development results in products that can be produced an... -
In designing a machine component, there is no rigid rule. The problem may be attempted in several ways. However, the general procedure ... -
The terms first angle projection and third angle projection may seem like complicated terms but the reason for their naming is connected ... -
Axonometric projection is shown in Figure 2.3. This is the same as perspective projection except that the projectors are parallel. This ... -
The movement of the tool relative to the work is termed as “feed”. A lathe tool may have three types of feed-longitudinal, cross, and angula... -
AMF Bowling is a market-pull enterprise. AMF generally drives its development process with a market need and seeks out whatever technolog...
.
0 comments:
Post a Comment