Unscrewing System

To remove a product that is threaded on the inside, the mold that form the screw must be rotated in the opposite direction from the direction of threaded products. Player power can be generated by a straight motion from the mold openings are converted into rotary motion by means of transmission such as worm gear, or by adding a separate player. Below are shown examples of mold unscrewing system with its own player. As the player is connected to a motor. With through existing trnsmisi gears on the axle TSB core rotates in the direction opposite the direction of threaded products. At the base of cores threaded bushing installed with the direction and magnitude equal pitch screw threaded products. Because the threaded bushing above also serves as a nut, then the opposite direction when the screw rotated cores, cores will retreat and escape from the grip of the product, wherewith products are free from cores driven down by stripper plate. At the opening of the next mold, plates 1 and 2 open, runner pin sinking of the surface of the plate so that the runner down. To avoid co-rotating products during core spinning off product, at the end of the tooth or indentation formed male.